To remove the glove box in a Jeep Wrangler, first open the glove box and locate the screws or bolts securing it to the dashboard. Remove these fasteners using a screwdriver or socket wrench. Next, gently pull the glove box towards you, disengaging any clips or tabs holding it in place. Finally, disconnect any electrical connections if applicable, and the glove box should come free.
The fuse panel for a 2003 Jeep Wrangler is located behind the glove box. The owners manual describes how to remove the glove box to access the panel. Removing the glove box is simple.
The cabin air filter is behind the glove box. You have to remove the glove box to get to it.
It's behind the glove box. Open the glove box and remove the strap on the right side, the box will fall right out.
Look behind the glove box
Open the glove box, it is behind it.
The glove department must be hooked on the three latches. If not, then the glove box will not close.
right below the glove box
Behind the glove box.
The fuse box is behind the glove box door.
When you open the glove box look for the strap on the right side of it. Slide it out of the slot on the glove box. Be sure to hang on to the glove box, because it will now drop open. Open the box far enough to allow the hinges to slide out from the dash, and remove it. Once you do it, it's no problem.
When you open the glove box look for the strap on the right side of it. Slide it out of the slot on the glove box. Be sure to hang on to the glove box, because it will now drop open. Open the box far enough to allow the hinges to slide out from the dash, and remove it. Once you do it, it's no problem.
behind the glove compartment.