0
for any auto repair, consult your repair manual. if you do not have the required tools, manuals or knowledge to complete the repair then you need to consult a certified mechanic.
any mess-ups that you make while doing your own mechanical work can be catastrophic. engine parts must perform their job up to 100 times per second, and anything that is installed incorrectly can cause bad performance or even system failure, possibly damaging other components and increasing repair costs.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
How do you change the ignition switch in a 1988 Chevy Camaro?
How do i change the ignition switch in a 1988 Chevy camaro
1988 jeep wrangler runs while cranking quits when you let off?
you have an open circut in your ignition switch change your ignition switch.
How do you change or fix an ignition switch on a 1988 Corsica when the key turns but does not actuate anything?
If your 1988 Chevy Corsica key only turns in the ignition and does not start the automobile, it is probably unfixable. Remove the ignition switch retaining ring. Slide the out and remove the wiring harness. Reverse the process to install the new ignition switch.
How do you install ignition switch 1988 gmc truck?
You need to remove the steering wheel first with a puller. There is a latch you can trip with a small screwdriver that will let the ignition switch slide out. Simply replace the switch and put the steering wheel back on.
How do you remove the ignition switch in a 1988 Isuzu pickup?
how to remove lock cyliner switch 1988 Isuzu pickup
How do you install key ingition switch 1988 Chevy S-10?
how do install key ignition switch 1988 Chevy s10
How do you repair the ignition system on a 1988 Jaguar xj6 that will not turn off the engine and does not kill power feed to dash?
sounds like u need to change the ignition switch itself ( the keybarrel)
How do you change the ignition control module in a 1988 Chevy Silverado 5.7 L?
How do you change the ignition control module in a 1988 Chevy Silverado 5.7L
How do you remove the ignition switch from a 1988 Dodge Ram 50?
Ignition switch and lock cylinder removal 1988 Dodge Ram 50.Disconnect the negative battery cable from the battery.Remove the steering column cover to gain access to the ignition switch/lock cylinder.Using wire cutters, remove the cable band.Remove the bolts that hold the ignition switch/lock cylinder to the steering column.Unbolt and remove the key reminder switch and remove the switch lock cylinder from the steering column.
How do you bypass the neutral safety switch on a 1988 dodge d100 truck?
you can disconnect the starter relay and run a wire from the starter wire in the connector to the power wire on it p.s. it is easyer to take a curcit tester and probe the connectors with someone truning the ignition switch to fine the starter the starter wire is brown and im not sure about the power lead from the ignition switch
How do i change the ignition key switch in a 1988 gmc sierra?
Should be able to rent steering wheel puller from part store then pull wheel ta da its in there!
How do you set the timeclock in a 1988 Chevolet Celebrity?
With the ignition switch on and the radio OFF, push the set button. Then use the Seek and Scan buttons to change the hours and minutes.
