The JOHN DEERe L130 lawn tractor typically requires about 48 ounces (1.5 quarts) of oil when equipped with its 22-horsepower engine. It's important to use the recommended oil type, which is usually 10W-30 or 5W-30 for general conditions. Always check the owner's manual for specific maintenance guidelines and oil capacity, as variations may occur based on engine and model specifics.
To replace the front wheel on your L130 John Deere lawn mower you need to first take out the old one. Place the jack under the front wheel frame of the lawn mower, then place the new bushings over the axle hole in the wheel.
Take a look at www.transportdimensions.com
Take a look at www.transportdimensions.com
10 to 15 liters of oil is the amount of oil that the John Deere 1971 920 tractor takes.
john Deere 318 what oil in hydro does it take
take it to a john deere dealership
It takes Filter # M801002. They can be found at your local John Deere dealer.
The John Deere X320 is recommended to run 10w-30 Turf Gard oil in the motor, however any 10w-30 motor oil from a local parts store will work as well.
I don't know much about that model but on most riding lawnmowers, there's a pin on the back underneath the seat that shuts off the tranny (for pushing the mower similar to taking a car out of gear). Reach back there and release the pin & jiggle it a little to make sure it's not engaged and that should do the trick. If that doesn't work, then you likely have a broken drive belt and/or pully. Take it to a repair shop or find a buddy who knows basic auto/engine maintenance.
how do you take the boom cylinder apart on a john deere 310c backhoe
Write down the serial number and take it to your John Deere dealer.
9 quarts