Wiki User
∙ 10y agoan elongated object without the need to show the entire sectional view. Instead of
projecting the section onto an adjacent view, the resulting section obtained from the cutting
is revolved 90° and is placed on the same view
while Removed section is similar to revolved section in that only the cut plane is shown.
However, the section is placed elsewhere on the drawingWiki User
∙ 10y agoA revolved section is made by revolving a cross section view 90° about an axis of revolution and superimposing the section view on the orthographic. A removed section is similar except the view is removed to another part of the drawing. : )
Power supply: Water pump, producing pressure at its output valve.Resistor: A section of pipe. Flow of water loses energy on the way through, due to friction with the pipe's interior wall.Potential difference: Difference in water pressure between the beginning and end of the pipe section.
An 'U' beam is a beam that is shaped like the letter 'U'. It is usually made of 3 parts; 2 sides and 1 bottom piece. A beam would normally refer to an 'I' beam (A beam that is shaped like the letter 'I'). The difference is that cross section of the beams are different.
The shear center is the point on a beam cross section at which an applied shear force (lateral load or load parallel to the cross section) will produce bending but no twisting of the section. The center of twist is a point in a cross section that remains stationary when a twisting moment (torque) is applied on that cross section. The shear center and twist center are the same point only when the beam is rigidly supported.
Resistance is the value of a given wire in ohm but resistivity is value of the material with which that wire is made in ohm meter. R = rho * L / A Here rho is resistivity and R is resistance. L is the length of the wire and A is area of cross section
A revolved section is made by revolving a cross section view 90° about an axis of revolution and superimposing the section view on the orthographic. A removed section is similar except the view is removed to another part of the drawing. : )
1. Full Section 2. Half Section 3. Local Section 4. Offset Section 5. Revolved Section 6. Removed Section
difference between cross section and block daigram
no ans
A full section is an entire section. A half section is half of a full section.
The BAU is a section of the NCAVC.
A chapter consists of different sections.
Sectioning is the process of drawing an object imagining it to be cut throw by a cutting object. TYPES OF SECTION. Full section, Half section, Part section, Broken section, Revolved section, Scrapt section
A cylinder has a circular cross-section whereas a cuboid has a quadrilateral cross-section.
What_are_the_difference_between_a_section_common_property_and_exclusive_use
A cylinder has a circular cross section, a rectangular prism has a rectangular cross section.
A cylinder has a circular cross section, a square prism has a square cross section.