0
The ejector located inside the left side of the receiver is drug reward by a leaf spring on the bolt on this rifle. The ejector has a shoe on the forward end which is part of the chamber and assists the extractor in removing the cartridge from the chamber. About halfway to the open position a coil spring located in a slot on the left side of the receiver under the thin metal cover overcomes the bolt spring pressure and pops the ejector loose and returns it to its forward home position. As the bolt continues rearward a lip on the back end of the ejector contacts the cartridge case rim and kicks it out when the bolt is fully rearward.
Add your answer:
Earn +20 pts
How do you get the bolt back in a Remington 592M?
how do you get the bolt back in a remengton 592
How do you Replace extractor in Remington model 742?
Best left to a gunsmith
How to Assemble the extractor - pin - spring Remington 550-1?
Best left to a good gunsmith
How do you replace a Remington 7400 extractor?
The Remington Model 7400 extractor is a semicircular shaped part made of spring steel that is held in its correct location with a rivet. This rivet needs to be properly staked in place and blended with the outside diameter of the bolt head. This is a job that should be done by a competent gunsmith that has the correct equipment to do the job properly. The model 7400's extractor was changed from the earlier model 742's which as noted above was riveted in. The model 7400 has a snap in extractor - no rivet. I replaced mine by inserting a curved tool (I modified a small thin screwdriver by bending the tip) through the magazine well under the extractor to pull out the remainder of the old extractor, then snapped in the new one. The new extractor cost 20 dollars (with shipping and tax) from Remington.
Where can you get parts for your 5mm Remington 592m bolt action?
Well, isn't that a happy little question! You can find parts for your 5mm Remington 592m bolt action rifle at your local gun shop or online retailers that specialize in gun parts. Just remember, it's all about enjoying the process of fixing up your rifle and bringing it back to its full potential. Happy hunting for those parts, my friend!
What level of maintenance is the extractor and ejector?
there is no real 'maintenance' for the extractor or ejector. they work or don't work (when broke). just wipe clean after shooting............................
How do you remove-replace The extractor on a mod 514a 22 cal?
If you mean a Remington 514 series bolt action rifle, the extractor is L shaped, and pulls straight out from the side of the bolt. If not careful you will lose the extractor plunger and spring. I would take it to a gunsmith- getting the new one in requires fitting.
How do you get the bolt back in a 592M?
how do you get the bolt back in a remengton 592
Which is the better rifle for 30-06 Remington or savage?
This is an opinion. I like Remington. Feels good, looks good and nearly impossible to beat for accuracy especiall the Mod 700. Some might not like the price and some will crtisise the Remington extractor / ejector system. If you want fast follow up shots without sacraficing looks, power or accuracy the Remington 7600 is unbeatable.
How does an extractor fan work?
An extractor fan is used for better ventilation and to extract moisture from the room, thus making the air less humid. It also helps to prevent condensation.
How does a semi auto pistol extractor and ejector work?
When the slide or bolt moves to the rear, part of that bolt- the extractor- grips the rim or groove of the cartridge case, and pulls it out of the chamber. At the end of the stroke, another part, the ejector, flips the cartridge out from under the extractor, and out of the gun.
What is the antonym for extractor?
An extractor is a word for a fan that you often find in bathrooms. An antonym for extractor is introducer.
