Please tell me how to install the bolt in a Remington Model 512
The Remington model 700 bolt handle is part of the bolt body and this is a one piece forging.The only way to remove the bolt handle is to cut it off at the bolt body.
Actuate the bolt to the rear and there is a tang in front of the trigger that hangs down..Press up on this tang and pull the bolt back and it will remove it from the action.
Yes
Follow the instructions in the owner's manual. If you don't have one, go to Remington's web site and request one.
The Remington model 700 bolt handle is part of the bolt body and this is a one piece forging.The only way to remove the bolt handle is to cut it off at the bolt body.
on the rear of left side of the bolt between the bolt and the receiver housing is a small lever that mist be pushed down with a small screwdriver. hold down and pull the bolt out.
Because the bolt stop is broken..they have a plastic bolt stop.
First take off the stock. Second pull down on the bolt stop pin located in front of the trigger. Third while holding down on the bolt oin remove the bolt.
Model 58 is an automatic not a bolt action
To remove: Open action, press trigger rearward and pull bolt entirely from receiver. To install: Insert bolt in receiver, push bolt over plunger in bottom of receiver, pull trigger and complete forward travel of bolt; then rotate bolt handle downward to lock.
Adjust? You mean to remove or tighten? There is a threaded tightening bolt right in front of the receiver over the barrel.