The Remington model 700 bolt handle is part of the bolt body and this is a one piece forging.The only way to remove the bolt handle is to cut it off at the bolt body.
Follow the instruction in the owner's manual. If you don't have one, you can get one at Remington's site.
Request a manual from Remington's web site.
Just in front of the trigger there should be a small little button thing. Just hold that in and then work the bolt back and it should come out.
Removing the bolt handle is a bit involved. If you slide the ejection port dust cover back and forth slightly until the cut-out on the top of the dust cover is over the bolt handle top you will see the end of a pin. This pin holds the bolt handle in place in the bolt. Unless you have the ability to completely take-down this rifle and then re-assemble it to working order, and have the tools to do so, it is NOT recommended you remove the bolt handle retaining pin.
open bolt,pull trigger,bolt should slide right out
No, there is not a diagram to take apart the outside of a door handle. However, there is a diagram that shows how a door is held together, and from there a person can take apart the outside door handle.
take bolt off
if you are talking about just the handle is broke there is just one bolt in it you just have to to look in the hole where the handle was and take the bolt out get a new handle and put bolt back in
You can request an owner's manual for free at the Remington website.
You can request an owner's manual for free at the Remington website.
You can get a manual from Remington by going to their website