0
I just finished replacing the ignition key system in my 1993 G20 Chevy van, 350ci, tilt steering wheel, no air bag, two key system.
1. disconnect the negative battery wire from battery.
2. remove steering wheel with an appropriate puller and disconnect horn wires.
3. remove retainer ring (2 tork screws at 11 o'clock and 8 o'clock)
4. compress locking ring with compression tool specific for this purpose and remove retaining clip. remove ring.
5. remove horn contact ring and spring.
6. unscrew directional signal lever arm (1 Phillips screw) and remove. Take note of location and orientation.
7. unscrew turn signal switch (3 Phillips screws) Pull over steering shaft and set off to the side. Do not remove or pull on wiring harness.
8. turn key to run position and remove lock retaining screw (phillips screw at 3 o'clock) do not drop screw down steering column!!
9. remove ignition cylinder.
10. install new cylinder ($13.99 at any parts store)
Hope this helps. Time taken 2 hours.
Still curious? Ask our experts.
Chat with our AI personalities
Vivi
Steve
TaigaAdd your answer:
Earn +20 pts
Does a 1988 Chevrolet G20 Van have points or an electronic ignition?
electronic ignition
A diagram from a 1991 Chevy van G20 heater core box that a heater core come out of?
diagram for a 92 Chevy van g20 Heater core
How do you replace a wheel bearing assembly on a Chevy G20 Van?
Front or rear?
How do you find Key code 1993 Chevy van g20?
call your local friendly gm dealer and have your vin ready
Where is starter on an Infiniti G20?
look from the bottom on the back side of the engine you'll see it there. When you get under the car, it's in the middle of the engine/gearbox, above the exhaust, to left from the oil pan. it's easier to see if from the right side (passenger).
