Cross Bow
Crossbow
1. A weapon for shooting arrows. It is faster than a long bow. The long bow shoots further and with more force. 2. A ribbon for the hair or clothing. 3. A show of respect.
Original Answer The magic short bow is better. Dark bows take a long time to get xp with, but hit higher. Improved Answer by IR o IF L The MSB (Magic Short Bow) is one of the best, if not the best, range training devices. It deals an accurate blow, and usually does a good amount of damage with iron+ arrows. The speed of this bow, compined with the accuracy, makes it the best training device for range [other than Chinchompas] in RuneScape. The DB (Dark Bow) is actually one of the slower range training weapons. It may deceive you by its high hits, but the fact that it just doesn't hit those high hits often enough ruins it. It attacks a little bit slower than a longbow, although it shoots two arrows. Very costly, which is also a downside. DB shoots 2 arrows - MSB shoots 1 On average, you will shoot 2.2 arrows from the MSB every 2 arrows you shoot from the DB, just because of the sheer speed of the MSB
no it is impossible It is possible if you have a very large arrow rest for all 10 arrows, but all the arrows would be slow and falling short because the same energy is now shared by 10 arrows.
No, it is a short range weapon
it shoots a lot of bullets in a short time
6 or 8 bolts Beleve it is 6
For a Smith and Wesson revolver in stainless steel that shoots short bullets, you might need a 380 caliber pistol or a S&W 32 caliber revolver.
You pull the lever to make the dragon fall asleep and then, in the short time you have, you have to fire the arrows in his mouth. You have to do that 3 times and then you have defeated him.
according to chilton repair manual. long bolts- 46 lbs short bolts- 43 lbs then after torqued, tighten an additional 90 degrees. the long bolts are the bolts under the valve cover. the short bolts run along the exhaust side of head
65 on the long bolts 45 on the short bolts
There are 7 bolts going into the water pump, 4 long and 3 short. The short bolts will go into the 12:00, 5:00, and 7:00 O'clock positions. Look for those 3 (short bolt) positions to have the timing chain cover threaded. The timing chain cover for the 4 long bolts will be smooth. Glad I could help.