answersLogoWhite

0


Best Answer

A cutoff operation separates parts from a strip by shearing one edge of each part in sequence. A partingoperation cuts a slug between adjacent parts in the strip.

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is the difference between parting and cutoff operations?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What will be the expected cutoff for INCHO 2012?

between 55 and 60


How do you tell the difference between 100 amp and a 200 amp box?

If this is a new box there should be a rating label on the box. If it is an old installed box and you can see ratings, look at rating of mail cutoff breaker.


Give the difference between LPF and HPF?

LPF is a low pass LTI filter which passes the low frequency signals and reduce the amplitude of the signals with frequencies higher than the cutoff frequency. HPF is high pass LTI filter which passes the high frequencies and reduce the amplitude of the frequencies lower than filter's cutoff frequency.


What is the cut off time for Fed wire?

Below is a link to the fedwire transaction information. However, check with the bank you are wiring through because they may have an earlier cutoff time in order to ensure their transactions go through before the cutoff. http://www.frbservices.org/operations/fedwiretesting/fedwire_hours.html


What is early cutoff in auditing?

early cutoff


What college can you get for your cutoff?

what college will get for cutoff 170


What are the differences between exospore and endospore?

The difference between an exospore and an endospore is simple. An endospore is a spore produced within the cell wall of a mother cell and released when the cell wall ruptures. An exospore is cutoff by the cell division of mother cell wall. They are released one at a time.


What does the switch on the side of a browning a500r do?

This switch operates the Magazine cutoff. The cutoff enables the gun to open the chamber and remove the shell to insert a different shell into the chamber, but it is done while the magazine remains loaded. This way, the chamber can be emptied and the extra shells in the magazine will not automatically load. Recommend you use the link below to the Owners Manual for the A500 model. The Magazine Cutoff operations are shown on pages 29 and 30.


What cutoff did the donner party take?

They used the Hastings' Cutoff


When was Lucin Cutoff created?

Lucin Cutoff was created in 1904.


Where is the fuel cutoff switch located on a 2003 Dodge Durango?

Dodge does not use inertia/cutoff switches.Dodge does not use inertia/cutoff switches.


Last year lateral entry cutoff mark of be?

100% is the cutoff