answersLogoWhite

0

I've always used the term 'face shovel' where the 'bucket' breaks-out

the ground and loads itself while moving in a direction away from the operator.

A back-hoe

works back toward the operator.

Back-hoes

are good for digging holes whereas face shovels generally work ground above their 'feet'.

User Avatar

Wiki User

12y ago

What else can I help you with?

Continue Learning about Engineering

What is difference between C and lisp?

If i know the answer i better open face book rather than this...


What is difference between elastic and elastic plastic analysis how can one determine wether its elastic analysis or elastic plastic analysis in ANSYS?

your face for gods sake


What is difference between face to face and end to end in valve dimension?

Face-to-face (FF) and end-to-end (EE) are two different measurements used in valve dimensions. Face-to-face refers to the distance between the two faces of the valve's flanges, which is critical for ensuring proper installation and alignment within a pipeline. End-to-end, on the other hand, measures the total length of the valve from one end to the other, including any protrusions or extensions. These measurements are essential for compatibility with piping systems and to maintain the integrity of flow within the system.


What is the difference between a scarf and a muffler?

A scarf goes around your head, face or neck to keep your neck/face/head warm. A muffler goes over your hands, putting your hand in each end. A scarf is a long band of fabric. A muffler is a short, round, hollow roll.


What is the difference between 6A-6B and 6A-6BX flanges?

6A-6B flanges are ring type joint which is not developed for face to face make up, where the bolting forces act on gasket. 6A-6BX flanges are also ring type joint but it is developed with raised face hence the bolting forces act on this raised face and not on the gasket if it is properly placed. And also the raised prevent the flange damage from excessive bolting torque.