IP is the internet protocol that uniquely identifies a system on a network and there is no difference between IP and IPv4 infact IPv4 is a version of like IPv6.
difference between ip address and class
jjj
Dhcp is Direct host configure protocol. This is used to assign IP address Automatically. In a Domain Environment we must need IP Addresses to communicate with one machine to another to access the resources, their are mainly two ways to configure a IP in a system One is static or manual IP and other is Dynamic or Automatic IP. So DHCP help us to configure an IP Address Dynamically.(Network+ Guide to Networking answer)BOOTP relies on a static table to associate IP addresses with MAC addresses, whereas DHCP does not
h.248 helps mgc controle mg. sigtran helps ss7 transported through Ip network.just so so.
IPv4 1) Header (20-60 bytes). 2) Routed Protocol. 3) Types of address: i) Unicast ii) Multicast iii) Broadcast (limited/Direct) 4) 32-bit address. 5) Address space is 2^32. 6) Format of address : Decimal dotted. 7) IPsecurity support is optional. IPv6 1) Header is fixed (20 bytes). 2) ICMP6, IP 3) Types of address: i) Unicast ii) Multicast iii) Anycast 4) 128-bit address. 5) Address space is 2^128. 6) Format of address : colon hex notation. 7) IPsecurity support is built in.
IPV4 is a kind of IP Address.
IP is the internet protocol that uniquely identifies a system on a network and there is no difference between IP and IPv4 infact IPv4 is a version of like IPv6.
The difference is in the IP range. The multicast IP range is 224.0.0.0 - 239.255.255.255
Hardware address is the MAC address. IPv4 is the IP address. The MAC address is assigned to each network device at the time it's manufactured and does not change. The IP address is manually assigned and can be changed.
a TcP IPv4 ip address has 32 bits.
IP version 4, i.e. IPv4 is most prevalent today.
On a Cisco router, the command to enable IP routing (for IPv4) is:ip routingTo disable it:no ip routingOn a Cisco router, the command to enable IP routing (for IPv4) is:ip routingTo disable it:no ip routingOn a Cisco router, the command to enable IP routing (for IPv4) is:ip routingTo disable it:no ip routingOn a Cisco router, the command to enable IP routing (for IPv4) is:ip routingTo disable it:no ip routing
both are versions of internet protocol (IP)they both have private IP addressingThey both allow multicast
In.addr-arpa (ali66reza)
difference between ip address and class
IPv4
What is difference between public ip and isdn