It is a very large bore shotgun that with solid shells was also used as an elephant gun. It was also used to shoot geese at a long range.
Take it to a gunsmith to be sure.
Its quite simple as that it ejects the shotgun shell out of the gun after it has been fired but this depends on the type. A double or single barrel shotgun would only eject the shells when u hit the release mechanism to reveal your side of the barrel then they eject out.On any other type shot gun where u load 8 or have a clip they generally fling out the side when re-cocked or if automatic they do this automatically. Hope i helped
Ensure you look at the stamped shell gauge on the side of the receiver (12 or 20 Gauge). Should be able to take 2 3/4" and 3" shells.
Remove the trigger assembly,Remove the sears, Remove the top lever spring, Remove the set screw for the lock, Remove the left hammer spring.
Usually, there is a floor plate area just in front of the trigger mechanism, ahd you slide the shells in there one at a time with the brass toward the trigger; that's in a pump gun. Remember, it will only hold 3 shells in the magazine, but go ahead and pump it once, and you can put another in the mag, thus having 4 usuable shells in the gun. Obviously, if it's an over/under, or side by side, you have to break it open and slide the shells in one at a time.
Store brand shotgun with two barrels, side by side.
Their shells provides protection for their weak back side.
For the Stoeger side-by-side shotgun, your best bet would be to use any of the standard Winchester choke tubes. They should fit well for you shotgun.
Condition is important. $50 on the low side to perhaps $150 if pristine. Be aware that one shouldn't fire modern shells through it; stick with 2 1/2 inch shells. Polywad.com has a line of shells called Vintager that should run through the Diana acceptably.
"Shotgun" means the passenger side.
Yes, if it is unloaded while the other is not.