This is from the owners manual for a FEG MARK II PMK-380
Disassembly
Warning: Keep the safety "on safety" and do not cock the hammer. Take out the magazine and clear the chamber by pulling open the slide and looking in the chamber to be sure it's empty.
Field stripping takes no tools. Do not pry or hammer on this pistol.
With the pistol unloaded, hold the grip firmly in your right hand and put your right index finger along the side of the trigger guard. With your left hand, pull down the trigger guard. When it comes out of the frame, press it sideways with your right index finger to keep it from springing back up into the frame.
With your left hand grab the slide by it's grooves and pull it all the way back until you can lift the back end up, clear of the frame. Ease the slide forward and off the pistol. Be careful not to let go of the slide while you can still feel the spring tension, or it could fly off the pistol and be damaged. Pull the recoil spring off the front of the barrel. No other disassembly is recommended.
Assembly
Warning: Before you start, check the barrel to be sure there is no cartridge in the chamber.
Put the recoil spring, small end first, on the barrel. Cock the hammer. Pull the trigger guard down out of the frame. (See Disassembly)
Put the slide over the forward end of the recoil spring and pull the slide back onto the barrel all the way until it stops. Then push the rear of the slide down until the grooves inside the slide line up with the rails on the frame. When properly aligned, ease the slide forward and let go of the trigger guard so it goes up into the frame.
Before you load the pistol, move the slide back and forth and check the other functions for proper assembly.
Care and Cleaning
WARNING! UNLOAD THE PISTOL BEFORE YOU START TO CLEAN IT! How many times have you heard this excuse for gun accidents? "I was cleaning it and I didn't know it was loaded."
Take out the magazine, open the slide and check the chamber to be sure the pistol is unloaded. Disassemble the pistol as described in the DISASSEMBLY instructions.
A good quality modern gun solvent and gun oil or light household oil are all that is needed to care for this pistol. Wipe all surfaces with a soft cloth or cleaning patch soaked in solvent. Do not try to clean the gun with oil. It will not disolve the residue left by smokeless powder cartridges. Oil very sparelingly!
Would need to know the model to answer.
Need to know what model before an answer can be given. assuming you are refering to a colt 45 semi-auto pistol the date would be about 1914
Need to know what pistol???what pistol ????????????????22 win mag m-s made by rexio Argentina
impossible to know
What would you like to know about this pistol? I've done quite a bit of research on these.
We do not know the name of the first pistol smith- that would have been some time in the 1400s- or earlier.
made by Colt in 1943. Value would depend on overall condition of the pistol............
You will need a professional appraisal and contact Colt to get a historical letter.
I have a colt 32 automatic hammerless pistol and i would like to know the value of it.
When you get to the point where it is clear that life would be better apart than together.
yes, yes they are a fifth grader would know that
Without the strong force atoms would fly apart and nothing would exist as we know it.