Best left to a gunsmith
While hunting, yes. Otherwise, no.
Remove the cap from the end of the tube and be careful of the spring which is under pressure. The plug will come out with the cap.
Best to ask a gunsmith for help.
Best left to a trained gunsmith.
Remove the 2 screws from the end or the mag tube and the cap and spring will come out. Do so carefully as the spring is compressed
most pump shot guns have a cap on the tube below the barrel, this must be screwed off to remove the plug, be careful game laws limit the number of shells allowed
the lower tube has a removable round nut, remove it slowly a spring will come out, the plug is at the bottom, turn over the shotgun and the plug will fall out. make sure of local game laws if your taking it into the woods. every place has laws and limits on the number of rounds a gun can carry
Remove the gas system. Drift out the black cross pin out of the magazine tube. The pin is directly below the gas system through a polymer plug. The polymer plug should come out of the top of the magazine tube when you remove that pin, so be VERY careful when removing the pin. Now remove the magazine spring. On the follower end of the spring should be the plug you are wanting to remove. Remove it from the spring. And put the spring and polymer plug back in. The dished end of the polymer plug goes toward the end of the magazine tube.
Most hold ammo in tube under the barrel. Make sure firearm is empty then unscrew the end cap on tube/magazine. Plug should be there.
the limiter plug is in the end of the magazine tube.just loosen end nut cap,remove barrel,pull off slide,then point towards ground,limiter plug should fall out;then reassemble without limiter!if you have problems read your manual or read online manual at stoeger.com !
Wooden dowel