answersLogoWhite

0


Best Answer

Factory applied or after market?

Factory applied would be great to know.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you remove the recoil pad on a Browning citori?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you remove the recoil pad on Browning Citori?

Factory or aftermarket?


How do you change the recoil pad on a Browning Citori?

Factory applied or aftermarket?


How do you remove the recoil pad of a Browning Citori?

If you look close enought you will see two small slits in the pad where it meets your shoulder. There is a screw in each of these slits. It requires a phillips head to turn them.


How do you remove the recoil pad from a browning a bolt?

Best left to a good gunsmith


How do you remove the recoil pad from a browning bar rifle?

Best left to a good gunsmith


How do you remove the recoil pad from a BPS synthetic stock?

Recommend you contact Browning at link below


How do you remove the recoil pad on BROWNING A-5 auto?

No way to answer without knowing how it is attached. Best left to a gunsmith.


How do you remove recoil pad browning xs skeet shotgun?

Usually there is a slot cut in the rubber or other type of pad. You should be able to fit a small srewdriver down to a screw.


Did a 1989 vintage 270 Browning BAR come with a factory installed recoil pad?

It would have come with a hard plastic buttplate with the word 'BROWNING' on it.


Did recoil pads come factory from browning in 1957 on the sweet 16?

No, never. Browning did not make any recoil pads standard on any A5 except the Mag12. For an extra fee, Browning would install it for you at their shops in the US, but it is not factory and was not imported from Belgium with a pad.


Value of a Browning Sweet sixteen gauge with a recoil pad serial number Y 53410 in fair plus to good condition?

50-350 USD or so


How do you remove butt stock on boito 410 shotgun?

Most likely there is a bolt lengthwise through the stock. You will need a long screwdriver to reach it, and may have to remove the recoil pad or buttplate first. The recoil pad is usually fastened with screws inside the rubber. You will have to feel for the holes, as the rubber closes over the screws.