If its tile. Use a heat gun. Or hair dryer. Warm it up and scrape it off. Then use a wax residue remover for the rest of the wax
Chat with our AI personalities
As long as the toilet sits level on the floor so that it does not rock and you tighten the bolts holding it down there shouldn't be a problem. Just make sure one of each size wax ring is enough.
If its new VCT probably, and you will need to strip the old wax & rinse good so there is no stripper residue.. it eats your new wax over time.... If it ceramic tiles NO.
yes....2 or 3 seals stacked
Yes you can install vct over existing vct. The existing vct must be well adhered to the subfloor, no loose tiles or cracked and chipped tiles. If tiles are missing or must be removed you will need to patch in those spots with a suitable portland cement leveler or new pieces of vct. You will need to sand off the wax layer that may be present on the existing vct because if it is left on it can wear loose over time causing adhesion failure of the new vct and glue. Sweep all dust and contaminants from the floor.
400!!