How do you disassemble a erma werke ep .25 hand gun?

Answer 1

WARNING!! WEAPON MUST BE FULLY UNLOADED!! remove clip, remove all ammo from clip, pull slide and visually look into feed and assure that weapon is not loaded. reinstall empty clip, pull triger and dry fire weapon to release sping tension. pull two sided lever pin above the trigerguard (two side pin is above triger and just forward) with thumb and forefinger down into the trigerguard area then push the slide forward being careful and slow looking out for spring and spring guide(that they do not pop out),slide forward untill you have separated the two,(frame and the slide). to remove barrel from slide, push barrel forward while holding slide and carefully pull barrel up and out of slide. to re-install it use a bic pen hold the tip of pen in through slide point slightly up and into the end of the barrel slowly guide and install the barrel in reverse as when removing.(push barrell in all the way out of slide, to assure that spring is in correctly. to install the slide back into the frame, install the spring guide into the spring with small pionty tip to the rear and the spring into the firing pin, and as one unit (that can be pushed together) put the small tip of the spring guide into the rear of the frame into the hole that is recessed into the slide guide (that is built as part of the frame),push firing pin into spring to lock with triger release,it has to stay attached to frame,pull lever pin and install the slide, and slowly push slide into the firing pin you may need to turn slightly the firing pin so that the slide will go back in place ,release the lever pin when the slide is all the way in place.