0
adjustment knobs located under the caps. Remove the caps, the markings indicate which way to turn knobs to move the strike of the bullet.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
If you have a scope on a 308 rifle how would you adjust for the elevation example if your ballistic table shows to adjust for 13 moa at 400 yards. at one quter moa on the scope how do you adjust?
You would have to have 52 clicks of adjustment.
How do you adjust a Nikon rifle scope?
No one can answer your question unless this is known...... Have you shot it with scope on? what is MOA adjustment for the scope? what is the yardage? Let me know & Ill walk u in.....
If your rifle shoots to the right which way do you adjust the sights to shoot true?
You will want to make your scope point to the right more.
Looking for golden eagle scope have rifle?
Gun shop, gun show, want ad, pawn shop
How do you zero mt air rifle scope fast?
1. Using a sandbag, set up your rifle so that it doesn't move around much.2. Aim the air rifle at a target using the iron sights.3. Adjust the windage and elevation of the scope until it is pointing at the target while the iron sights are pointing at the same target.4. Try it out, see what happens. Fire three shot groups and adjust based on the center of this group.
How to install a rifle scope?
Here's the basics on mounting the scope on a rifle. ( Assuming you have a scope mount on the rifle.) 1. Place the bottom half of the scope rings on the rifle first (Without the scope attached.) 2. Place the scope on the bottom half of the rings and adjust the scope mounts to comfortably fit your eye. When adjusted, tighten down the bottom half of scope rings to the rifle mount. ( The scope should have one cross hair adjustment at the top and one on the right.) 3. Place the scope in the rings and then put the top half of the rings on. Tighten them down, but not VICE tight, just loose. You still want to move the scope some. 4. Look through the scope and align the cross hairs level with the rifle barrel. The Vertical line should be straight up and down at a right angle with the barrel. 5. when you have the scope adjusted to your eye and the barrel of the rifle, tighten the top scope rings in a crisscross pattern a little at a time. Don't vice one down then go to the next one. Do it a few turns on each one until they are tight. A final note. If you have a small screw hole and screw at the back end of the scope mount (on the rifle) you may want to place the rear scope ring against that screw. This is a scope stop. This will keep the scope from moving back from the recoil. Some scope mounts have a long pad at the rear of the scope mount that acts the same way. It's usually necessary on high powered rifles not 22's.
On average what is the cost of a BSA Sweet 17 rifle scope?
The BSA Sweet 17 rifle scope is an affordable scope that's designed for beginning rifle users. Average prices on the scope range from $50.00 to $100.00 in most cases.
Can BSA scopes go on daisy BB rifles?
I don't think it's a problem for the BSA to fit any rifle provided it has a 'Scope Rail" on the rifle. I think the problem is which model Daisy are you asking about. If it's a Red Ryder or a Buck, then NO because neither of these BB rifles have scope rails on them. If it's any of the Daisy Powerline models or Daisy Winchester models then "Yes" they have scope rails and will take any Scope. However, a scope made for a rifle may not focus closely enough, nor adjust to the point of impact of a BB gun.
What is the best zoom scope for a high powered air rifle?
A 4 x 12 x 40 works great. Just make sure you can adjust the parallax down to 10 meters (or less) and that the scope is air rifle rated. The recoil of some air rifles will destroy non rated scopes.
How much eye relief does one need when mounting a 4-15 scope on a power master 760?
That will depend on the scope and your eyes- but is ABOUT 3.5 inches. (Distance between your eye and the rear lens of the scope) It is the distance where you see the full image in the scope. You adjust it by sliding the scope forwards or backwards in the rings before tightening them down so that it fits YOU when holding the rifle in firing position. Please note- failure to pull a heavy recoiling rifle in TIGHT to your shoulder will result in a cut over your eye from being whacked with the scope.
How far do you have to be to sight a airgun scope?
For a rifle that fires between 800 & 1000 FPS you should set your target at 60 feet. You will have to adjust for rifles that shoot at a slower FPS.
Why use a rifle scope?
Y not?
