The cylinder on most revolvers is not intended to be user removeable. Some have left hand threads. You will really need to check with a gunsmith on these- not a very common revolver. Sorry-
asdada
you get bleach and a wet towel and everyday you wash it and it will soon go away.
use a short piece of 1/8 inch dowell to push in the spring loaded pin on the cylinder hinge just enough to release the hinge. be careful when removing the cylinder that you dont lose the spring loaded pin.
To replace the door lock cylinder on a 2001 GMC Sierra, first, remove the door panel by taking out the screws and clips holding it in place. Disconnect the wiring harness and remove the interior handle if necessary to access the lock cylinder. Use a flathead screwdriver to push the retaining clip out of the way, then pull out the old lock cylinder. Insert the new cylinder, secure it with the clip, and reassemble the door panel.
how do i replace the maser cylinder on a 1995 GMC Sierra
What cylinder? Master (brake) cylinder? Rear Brake cylinder? Lock cylinder?
how to remove cover to replace ignition lock cylinder and what type of tools do i need
how to remove and install fenders on my 1994 gmc sierra
100-200 USD or so
how to remove a clutch pedal assembly 2004 gmc sierra
The Sierra Six looks like a ruger single six- or a colt peacemaker. Basically it looks like any pistol you would see on an old western movie. A good- low cost shooter....
on the cylinder head