answersLogoWhite

0

Yes, stress can also contribute to a delayed period.

User Avatar

Wiki User

14y ago

What else can I help you with?

Continue Learning about Physics

Why is the spring of the hardness tester never be left under tension?

Leaving the spring of the hardness tester under tension for extended periods can lead to deformation or permanent set, affecting its accuracy and reliability. Releasing the tension when not in use helps maintain the spring's elasticity and ensures consistent hardness test results.


How do you model inertial and transport delay using Verilog code?

In Verilog, you can model inertial delay using # delay model and transport delay using tran delay model. # delay model specifies inertial delay by adding a delay value after signal assignment, while tran delay model specifies transport delay using the tran keyword before signal assignment. Both delay models can be used to accurately model timing behavior in digital circuits.


Do high tension wires give off harmful radiation?

High tension wires, also known as power lines, do not emit harmful radiation. The primary concern associated with high tension wires is the electric fields they generate due to the flow of electricity, which may have possible health effects if someone is in close proximity for extended periods. However, the general consensus is that the health risks from these electric fields are minimal.


A sentence with the word tension?

The tension in the room was palpable as the two leaders faced off in a heated exchange.


What is the difference between end to end delay and packet jitter?

End-to-end delay refers to the total time taken for a packet to travel from the source to the destination. Packet jitter, on the other hand, is the variation in delay between packets caused by network congestion, routing changes, or varying traffic patterns. In essence, end-to-end delay is the total time taken, while packet jitter measures the variability in that delay.