ou have to pull your ashtray out and there is 2 screws in the slot where the ashtray slides in.Make sure you turn your radio off and keep the keys out of the ignition when your removing it or it will lock itself and you will have to get a unlock code for it to work again.After you take those screws out you pull the panel off and you can see how the radio pulls out.
Chat with our AI personalities
remove ashtray than remove the screws holding cigarret lighter housing then pull down the two metal clips on each side than pull the radio out
WHAT DO THE DIFFERENT COLOR WIRINGS MEAN IN MY CAR FOR MY TAPE DECK TRYING TO PUT A CD DECK IN TO MY CAR SO DONT NO THE THE DIFFERENT COLOR WIRING MEAN HELP ME
The car's User manual should have a wallet size card with a 4 digit code that you use to reset the radio when propmted
You need special radio keys to remove the radio. They can be purchased at the dealer.
How do you turn radio on on 1990 Mercedes 420 sel if there is no screen showing code request
Despite the claims of the radio starting at 1988, Satellite radio started at 1987, with the United States Army fiddling around with the radio.
The two vents on the upper part of the central panel can be taken off. There are two prongs that need to be pulled in on either side of each vent. Once those are out you can see more screws.
Tune the radio to the station you want, hold down the button of the preset you want it set to.
behind the radio hidden up amongst the bundle of wires, it is very difficult to access and replace
To take the radio out of a 1987 - 1990 Chevrolet Celebrity: First take off the lower dash trim panel, the one in front of the radio. 1. Remove the ash tray, then the slide it goes in on. This may require removal of the under dash cover. Reach up through the hole where the ash tray was and remove the wire from the cigar lighter, then take the nut off of the back of the cigar lighter socket. The socket will then pull out through the front. 2. Use a thin blade screwdriver and release the headlight knob from the shaft. There is a notch on the back of the knob, the release is in that notch. With the knob off remove the nut from around the shaft. 3. There is a plastic tab that goes under the dash panel to the right of the radio. Pull gently out on the trim panel to make it bow slightly, then the tab will pull out. 4. If the car has a rear window defogger unplug the switch wires. 5. The trim panel should now come off. Use care not to break it. 6. There are three screws that hold the radio in place, remove them and pull the radio out far enough to remove the antenna and wire plugs, then remove the radio, Re-installation is the reverse.