Your Wii remote is not working at all?

Answer 1

You should re-sync it by

1.taking off the battery cover

2.taking off the plastic flap near the disc slot at the front of the wii

3.press the red button inside your wii and hold for 15 seconds

4.press the button on your wii remote

this should work. If not so, make sure the wii sensor bar is plugged in properly.

or i found this on Nintendo.com in support

• Most Common: Wii Remote not being recognized by the Wii Console (lights on the Wii Remote flash when you press a button, but then go out) -

  Getting the Wii console to recognize (or "sync" with) a Wii Remote, especially one that did not come in the box with your Wii console, may require doing a few additional steps before it can be synced. Additionally, a Wii Remote that was working, but is no longer being recognized (or has "lost its sync") may need to be re-synced. Please use the troubleshooting steps listed below, which our experience has shown can solve many Wii Remote issues.

  1. Try these steps!

  2. Turn the Wii console power OFF by pressing the POWER Button on the front of the console. Unplug the power cord from the wall outlet for a few seconds. After a few seconds have elapsed, plug the cord back into the wall outlet.
  3. Turn the power of the Wii console ON. When you see the Health and Safety screen, open the small flap on the front of the Wii console to find a red button labeled "SYNC." Press and hold the SYNC Button down for 15 seconds. This will clear all the syncs on the Wii, allowing you to get a clean start to begin the process described below.
  4. After holding the SYNC Button on the Wii console down for at least 15 seconds, you can now "re-sync" your Wii Remotes:
     1. With the first Wii Remote you wish to sync, remove the battery cover on the back of the Wii Remote to find a small red button just below the batteries.
     2. Press and release the small red button just below the batteries on the Wii Remote; the blue lights on the front of the Wii Remote will blink.
     3. Quickly press and release the red SYNC button on the inside of the white flap on the front of the Wii console (picture).
     4. When the Player LED blinking stops and stays lit, the syncing is complete. The LED that is illuminated indicates the player number (1 through 4).
     5. This sync procedure (steps "a" through "d" above) must be followed for each additional Wii Remote added to the system.

  If you are still unable to get the Wii console to recognize your Wii Remote(s) after carefully following the steps above, please call 1-800-255-3700 for further assistance.

Answer 2

Yes