The button which has a red light on it, you should press it (the button) until it goes green. Then your PlayStation is on.
There should be an on button flashing red on the right if its plugged in. press that..... unless you have the old, fat PS2. on that one, there is a switch in the back. flip it. You should see the on button i told you about earlier flashing red. push it.
push the reset button on the front of the console .the light turns red in stand by mode. when it is green that means it is ready to play
NO
Smash it with a hammer.
you first have to flip over the board and open the battery compartment then you will see a little red button. Then go to your wii and open the compartment where you put your SD card ( in the front) and press the red button. go back to the board and press the red button you found earlier and press the button. if you do not see the blue power light flashing in the back of the balance board, you need to replace your batteries
What B button are you referring to, an Xbox B button? yes
There should be an on button flashing red on the right if its plugged in. press that..... unless you have the old, fat PS2. on that one, there is a switch in the back. flip it. You should see the on button i told you about earlier flashing red. push it.
You're kidding, right? Plug it in, the "Power/Reset" (I/O) button should have a red light, press that button. There's only two button on the whole console, it isn't too hard to figure out. Also.....To turn it off, press and hold the "Power/Reset" button. Sheesh.
There should be a 'Rewards' button in the main menu? (Red button)
All you have to do is reset your power slip.
Make sure the device is on. Hold down the tv (or whichever device your trying to program) button first and then the power button simultaneously until the red light stays on solid. Then press the power button, it will flash one time, and keep pressing slowly letting it flash until the device turns off. Then press the stop button...and it is programmed.
You hold down the power button for 4 seconds, until the light on the power button turns red.
Hit BIG RED SHINY BUTTON. If you don't have a BIG RED SHINY BUTTON, hit the button in front of the comptuer.
the power button
push the reset button on the front of the console .the light turns red in stand by mode. when it is green that means it is ready to play
red or yellow
Yes if you open the slot under the power button on the wii you can press a red button, then take the back off your controller and press that red button to make them sync.