A RF amplifier is a device for electrically amplifying the power of an electrical signal, typically, but not exclusively, radio frequency signals.
The intermediate frequency (IF) amplifier lies between the mixer and the demodulator. The mixer shifts the input radio frequency (RF) signal into the range of the IF amplifier. The IF amplifer is a band pass amplifier, so only RF signals that are the IF frequency distance away from the local oscillator in the mixer can pass through to the demodulator. This process is called the superhetrodyne process.
class C
gain in an op-amp is the output voltage divided by input voltage. for the inverting amplifier , gain(Av)=-(Rf/Ri) ,where Rf => resistance of the feedback path & Ri=> inverting input terminal resistance for the non-inverting amplifier , gain(Av)=(1+(Rf/Ri)) , where Rf => same & Ri=> non inverting input terminal resisance
Yes, but it will be less efficient than one designed for FM.
rf
the approximate efficiency of a class b linear RF AM amplifier is 35%
A unidirectional amplifier & a Bidirectional amplifier
A RF amplifier is a device for electrically amplifying the power of an electrical signal, typically, but not exclusively, radio frequency signals.
The answer to whether an RF power amplifier is useful for your home depends on the qualifty if your equipment. If your T.V. is getting a weak signal for example, an RF power amplifier may be useful to get a better signal.
Selective amplifier is an RF amplifier which selects particular frequency and amplifier so it can operate at fixed frequency.
The intermediate frequency (IF) amplifier lies between the mixer and the demodulator. The mixer shifts the input radio frequency (RF) signal into the range of the IF amplifier. The IF amplifer is a band pass amplifier, so only RF signals that are the IF frequency distance away from the local oscillator in the mixer can pass through to the demodulator. This process is called the superhetrodyne process.
class C
That depends on its purpose. Some examples:RF amplifier in IF stage of AM radio: 10KHz.RF amplifier in TV set: 6MHz.RF amplifier in IF stage of FM radio: 200KHz.An RF amplifier in a military RADAR set will probably have very narrow bandwidth to reduce jamming possibility, but wide enough to allow for doppler shift of targets.
Top coupling is a method of connecting the input and output of an RF amplifier circuit using capacitors on the top side of the circuit. It allows for direct coupling between stages without the need for additional components. Top coupling helps maintain the impedance matching and overall performance of the amplifier.
An RF cord plugs in the back of a tv and a AV plugs in the yellow in white oulet and RF cords are SNES and NES!!!!!!!!!!!!!!!!
The difference is in the output frequency.