in the oil filler hole
The same oil as you put in the engine!
where do u put hydraulic fluid in a Massey Ferguson 275
A MF 231 holds about 9 gallons of hydraulic oil and is added via a plug in top of the transmission housing.
A MF 231 holds about 9 gallons of hydraulic oil and is added via a plug in top of the transmission housing.
On the left side of the gear shifters
Beside the gear shift levers
There is a cap right next to the gear shifters. It's about 1-3/4" dia or so with a hex head on top. The hydraulics share the same fluid as the transmission.
put the stick on the right in the middle and turn the key
Hydraulic fill is on top of the transmission but be sure to remove both drain plugs at the trans and back end as they are connected before refilling.
The same place as a massey165
To add hydraulic oil to a Massey Ferguson 4225, locate the hydraulic oil reservoir, which is typically found near the rear of the tractor. Remove the fill cap, and use a funnel to pour in the appropriate hydraulic oil, ensuring you check the owner's manual for the correct type and viscosity. After filling, replace the cap securely and check the oil level using the dipstick if available, ensuring it is within the recommended range. Always perform this maintenance when the tractor is on a level surface and the engine is off.
There is a spout on the rear close to under the seat. See picture