answersLogoWhite

0


Best Answer

I just tried to replace my high pressure switch and I overtightened the new one... what a pain... so the whole A/C blew. Nevertheless, I think I understand your question. When you're loosening the switch you will notice a little leak through about two to three turns of the wrench. This is normal. Then remove the switch, replace the o ring, and put the switch back on. You may want to check your manual for specs on how tight to tighten the switch. Like I said, I overtightened mine and the threads separated from the switch and I leaked my whole A/C system dry.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: When installing new ac high pressure switch o ring blows from pressure release. how do i fix this problems?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you you increase psi on pump and filter?

by restricting the flow and installing a pressure switch.


How does an oil pressure switch work?

An oil pressure switch works by detecting the pressure of the oil in the car and alerting you to any problems. Oil pressure naturally increases when a car is running, but if the pressure gets too high or drops, it can create numerous problems.


What are the release dates for The Pressure Switch - 2007?

The Pressure Switch - 2007 was released on: USA: 19 November 2007 (limited)


When installing new ignition switch 1993 ford bronco I cannot get key to release?

make sure you put the switch in right side up and made sure you are pushing in the release button on the steering coloum -left side and make sure there is no pressure on the steering wheel from the steering box, hope this helps


Is there any advantage to installing the water pressure tank on the 2nd floor?

if the well pressure switch goes with the tank then the second floor pressure would more closely match the well pressure setpoints and the ground floor would have slightly higher pressure. with the tank and pressure switch on the lower floor the lower floor would more closely see the well pressure setpoints and the second floor would get slightly lower pressure.


How do you control the broadcast?

by installing switch you can control the broadcast


Do you have to reprogram the computer when installing a new ignition switch?

no


Can you change the fuel filter for a 1992 Dodge B250 to a generic one?

Yes if the filter your using has the quick disconnect like the OEM one has! If you are not able to find a generic one with the quick disconnect then it will entail installing your own connectors and cutting off the existing connectors on the OEM fuel lines. Be careful these lines are high pressure, you will need a fuel pressure regulator with release hose and pressure release button to release fuel pressure before attempting the switch. See the warnings and use a shop manual to follow all the safety precautions to attempt this modification.


Does a oil pressure switch monitor the oil level?

A pressure switch reads pressure not level.


Will you lose pressure if a pressure switch stays on on a well?

if your pressure switch acts up at all, replace it.


What does a ac pressure switch do?

A pressure switch a valve that shuts off the unit when the pressure is to low or to high


How do you check if the low pressure switch on a corvette 1977 is working?

Of which low pressure switch are you speaking? Engine oil pressure switch? If you're checking that, remove the oil pressure sending unit and temporarily put in an oil pressure gauge. If you're checking the AC low pressure switch, pull the switch from the AC low pressure line, Jumper the switch socket and see if the AC compressor comes on. If it does, you either have low refrigerant pressure or a bad switch. If you KNOW the pressure is up and everything else works, you have a bad switch.