how to change a belt on a 1993 gmc first get the proper belt .then you look at the pullies to make shure they are all good . now there is a pully dampener at the top .you got to lift or push it down to release the tention . now you can remove they belt .mack sure you put it back on they pullys the same way it came off they pullys .if in dought look at the front of your veihcal and there should be a sticker there an follow the sicker on they header panel for they routing
drive belt for what on this vehicle? do u mean serpentine belt,or fan belt,or timing belt?
The Villager has an electric fan and does not use a "fan belt".
To install a fan belt in a GMC Vandura, first, ensure the engine is off and cool. Loosen the tensioner or alternator adjustment bolts to relieve tension on the old belt, then remove it. Position the new fan belt around the pulleys according to the routing diagram (usually found on a sticker under the hood). Finally, adjust the tensioner or alternator to tighten the belt, ensuring it has the proper tension before securing all bolts.
Because it's broken...
Pull back the belt tensioner and slip the belt off. Reverse procedure to install.
how do you replace fan belt on 95 Chevy S-10 2.2 engine
2004 2.4 fan belt route
Should just be 4 bolts holding it on
-drain coolent -remove serpentine belt -remove clutch fan -remove rad hose going to water pump -unbolt and remove water pump
You have to take off the alternator to be able to reach the fan . After you should oiul the belt to slip on the fan very easy . Put the alternator back on and your ready to go .
You can find a diagram of the fan belt positioning on a 1992 GMC 1500 Sierra V8 in a repair manual. Haynes is a popular repair manual and is available from most auto parts stores.
The serpentine belt has a tensioner that you nust pry up to remove the belt. There should be a schematic of the routing of the belt on the fan shroud. If not, draw one before removing it.