lock them in tight.
You need to remove the door panel, the outside handle and lock unscrew the 3 bolts near the latch unplug elect plug and remove..The rear locks u need to remove the window rail on the left side to get lock out its 2 tight with rail installed
there are two flat bolt on top the the steering shaft that hold the lock in place but they are one time bolts so to remove them you either have to chisel a slot in them to use a flat head or you have to drill out the bolt the new lock assembly with come with new bolt with heads they break off once they are fully tight
1996 rodeo- how to remove key from lock ignition?
with a barrel lock key
you have to remove the steering wheel then using a lock plate removal tool depress the lock plate and removed the clip that holds it in place then remove the lock plate then remove the screws from the turn signal switch and pull it up slightly then remove the screw that hold the lock cylinder in place then remove the lock assembly
remove inner door panel for access to lock
To remove the tailgate lock on a 1989 S-10 Blazer, first remove the cover over the inside of the tailgate by removing the bolts on the side and on the handle. Pop the vinyl away from the tailgate. Then remove the bolts holding the lock on and remove the lock.
You have to remove the tire then remove the brake caliper and bracket then you will remove center greese cap and remove the carter pin and remove the will nut lock nut and washer jar the rotar to remove the outer bearing it might be tight due to a greese seal. Once the bearing is removed slide the rotar off.
Remove the drivers side door panel of your Mercedes-Benz. Remove the door lock assembly retaining bolts. Remove the door lock linkage. The door lock assembly will come off.
how to remove a door lock cylinder on 2000 dodge neon
Begin by removing the inside door panel on your 1997 Plymouth Grand Voyager. Remove the door lock linkage. Remove the door lock retaining bolts. The door lock will come out.