0
What else can I help you with?
How do you hookup a stereo mixer to a powered mixer?
stereo mixer output to powered mixer input
Can you connect a monitor to Yamaha emx5000 powered mixer?
Yes, you can connect a passive monitor speaker to an EMX 5000.
How do you connect non-powered mixer to power mixer?
To connect a non-powered mixer to a powered mixer, use a balanced audio cable (like XLR or TRS) to link the output of the non-powered mixer to one of the line inputs on the powered mixer. Ensure that the output levels are appropriately set to avoid distortion. Additionally, check that the powered mixer's input gain is adjusted to accommodate the signal from the non-powered mixer for optimal sound quality.
What is the best powered speaker?
The JBL EON15 G2 Powered Speaker is a very good powered speaker but of course it will run for a little more than our ordinary powered speaker.
How do you connect powered monitors to a powered mixer?
To connect powered monitors to a powered mixer, use balanced XLR or TRS cables. Connect one end of the cable to the mixer’s output jacks and the other end to the input of each powered monitor. Ensure the powered monitors are turned off while making connections to avoid any pops or noise. Once connected, power on the monitors and adjust the mixer’s output levels accordingly.
What is a powered audio mixer used for?
A powered audio mixer is used for combining, mixing, routing and changing the level, timbre or dynamics of audio signals. They can mix analog or digital signals depending on the mixer.
Are there any computer speakers that offer a microphone jack on on the front on the front of the speaker?
If you would like to plug a microphone into your speakers, Logitech offers a speaker with a port for a micropholne.
Is a peavey md12 mixer powered?
No. To use an MD-12 in as a sound re-enforcement mixer, you will need to have a separate power amp.
How can I connect a microphone to a speaker for optimal sound quality?
To connect a microphone to a speaker for optimal sound quality, use a balanced XLR cable to connect the microphone to a mixer or audio interface. Adjust the input levels on the mixer/interface to avoid distortion. Then, connect the mixer/interface to the speaker using balanced cables. Ensure the speaker is placed properly for optimal sound projection.
Do you need a new mixer if only one sound plays like your speaker is blown out?
If your speaker sounds blown out, it is probably your speaker. The mixer or input device you are using doesn't care what sound it is producing, as long as the level of the music is not too high.
If the camera has a powered mic input, you can plug it right in?
If the camera has a powered mic input, you can plug it right in
How much is a kmd PBM6-150 powered mixer?
I have 1 for $200 jonrider@ymail.com
