check the connectors at the wheel sensors probably got disconnected by the ice or snow
Cd stuck in a 2005 dodge magnum
Both a stuck reverse switch and shorted wiring can be causes for reverse lights to stay on. Under normal circumstances, the reverse lights turn off as soon as the vehicle is shifted out of reverse.
Your braces aren't going to get stuck. That's just a "RUMOR"
Take off both leads of the battery and leave them off for 2 minutes and then stick the leads back on and it'll reset the computer on the dash.
The actual cause was a defective wheel speed sensor which when replaced reset the indicators.
Disconnecting the power to the car, or computer for any length of time will not reset the check engine light, or service needed lights. The memory for these lights is stored in non-volatile memory of the computer in the car. In an OBDI or an OBDII system you must access the computer to reset these lights. As a suggestion if you have a local autoparts store they sometimes have a �Loan a Tool� program where you can rent a cheap computer access tool (This is not an endorsement, but I know Autozone rents this tool for both systems). If after resetting this light, it returns then you will need to correct the problem before it can be properly reset.
Disconnecting the power to the car, or computer for any length of time will not reset the check engine light, or service needed lights. The memory for these lights is stored in non-volatile memory of the computer in the car. In an OBDI or an OBDII system you must access the computer to reset these lights. As a suggestion if you have a local autoparts store they sometimes have a �Loan a Tool� program where you can rent a cheap computer access tool (This is not an endorsement, but I know Autozone rents this tool for both systems). If after resetting this light, it returns then you will need to correct the problem before it can be properly reset.
The ground ciruit for the headlights is by way of the headlight switch , the lights always have power
Try disconnecting the battery for about 10 minutes sometime this works Have vehicle scanned to have codes cleared
no
turn key to on position (do not start engine)press and hold both reset and trip buttons for about three seconds instrement cluster will run self diagnosis then all should reset.
Yes, they are both the same.