There is no fuse for the cruise control on a 1994 Acura Integra. It is a relay switch under the hood near the battery. This would have nothing to do with the dashboard clock, if the cruise control is not working properly. If the cruise control is not coming on, check the relay, then check the carburetor or EFI (Electronic Fuel Injector). Also, the cruise control will not come on if the brake light switch or the clutch is not working properly.
To use the cruise control on the PT Cruiser, turn the cruise control on in the steering wheel. Accelerate to the desired speed and push in the end of the left turn signal knob. The cruise control should then control the speed. To take the car out of cruise control, a person can tap the brake.
It attaches to throttle plate (next to throttle cable) to cruise control unit.
open hood and found that there is two throttal wires one for cruise control and the plastic mount had broke on the wire
a loose wire will cause that. also lots of other reasons but ford is known for cruise control failures in that year on all models
The cruise control computer module is located on the passenger's side of the engine compartment on a 1993 Mercury Villager.
Yes a 1991 Acura Integra does have a fuse for cruise control. The fuse can be found the in the engine compartment fuse box in the slot label 'cruise'.
Fuse for cruise control on a 1994 Acura Integra is found in the engine bay fuse box. The fuse is located in the slot labeled CRUISE.
The Chrysler Sebring cruise control switch is located beneath the dashboard, on the drivers side. The cruise control switch should be labeled as such.
The cruise control module of a 1993 Mercury Villager is located under the passenger side of the dashboard.
I think that the cruise control boxes are different at least in 91 teg they are the auto says at and the manual says mt.
The fuse for the cruise control on a 1998 Jeep Cherokee Sport is typically located in the fuse box under the dashboard on the driver's side or in the engine compartment fuse box. You can check the owner's manual for the exact fuse number and location. If the cruise control is not functioning, it’s also a good idea to inspect the brake light switch and the cruise control module, as these can affect its operation as well.
Cruise control is active.
Yes it could, if it is setting codes it will affect the cruise.
To the left of the steering wheel, below the dashboard is a button that says cruise control. Push that button in, the dash will illuminate the cruise control light. Then, as you reach the speed you want to cruise at, push the button on the steering wheel that says "set". When you want to turn cruise control off, simply tap the brake pedal and the cruise will go off.
In a 2004 Chrysler Sebring, the fuse for the cruise control system is typically located in the fuse box under the dashboard on the driver's side. You can find the fuse box by opening the driver's door and looking beneath the dashboard, near the steering column. Check the owner's manual for the exact fuse number and specifications related to the cruise control. If the fuse is blown, replacing it should restore functionality to the cruise control system.
On my 2000 accord the cruise control panel on the left of the steering wheel is out. But the dashboard light still works and so does the actual cruise control. As long as the cc still works its not a big deal.
The fuse for cruise control is typically located in the vehicle's fuse box, which can be found under the dashboard or in the engine compartment. To identify the specific fuse, refer to the owner's manual for the fuse diagram, which will indicate the location and designation of the cruise control fuse. If the cruise control is not functioning, check the fuse to see if it is blown and replace it if necessary.