The cruise control computer module is located on the passenger's side of the engine compartment on a 1993 Mercury Villager.
The 1995 Mercury Villager turn signal relay switch is located beneath the drivers side dashboard. The turn signal relay switch will be left of the brake pedal.
It is easier and cheaper to replace the entire axle. About $80.
Have vehicle scanned to determine the problem
Should be the same circuit for parking/tail/dash lights
Check fuses If you are getting power to socket, but not through it ,replace socket
The cruise control module of a 1993 Mercury Villager is located under the passenger side of the dashboard.
where is the PCM located on Mercury Villager 97
In the 1995 Mercury Villager, the computer control box, also known as the Engine Control Module (ECM), is typically located under the dashboard on the driver's side. It can be found near the steering column or behind the kick panel. Accessing it may require removing some panels or components for easier reach. Always consult the vehicle's service manual for detailed instructions and safety precautions.
the elictronic control sinsor at on a 93 mercury villager
In the dashboard behind the small grill to the right of the steering column.
There is no separate BCM. These functions are contained in the TCM under the dash.
Replace the transmission computer. Located under the center console.
The TPS provides a variable voltage signal to the computer to indicate throttle opening. There is no other function.
Powertrain Control Module
There is no such device on a '97 villager.
on my 1999 ford mercury villager its on top of transmission under the van
The ignition module and coil are contained inside the distributor and are not serviced as separate parts.