answersLogoWhite

0


Best Answer

http://www.therangerstation.com/tech_library/TFI_Diagnostic.html

Heat

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What causes ignition control module to fail repeatedly in 1991 Ford Bronco 302 FI?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What are the probable causes for no spark after changing the ignition coil on a 1973 Mercury Cougar?

the ignition control module could be the problem


What causes no spark in a 1988 Buick lasabre?

Crank sensor has failed,Ignition control module (ICM) has failed,Bad ignition coil pack,


What causes obd2 codes 1399?

p1399 is manufacturer control ignition system or missfire, this code could be coils,plugwires, or plugs,


What causes Ignition chime sounds without key in ignition?

Head lights on?


What causes 79 ford bronco to hesitate when driving?

poor tune up.


What causes a 2002 sable to stall and start after about 5 minutes?

If it stalls at idle or when slowing down, it could be a fuel filter. Or it could be the ignition control module.


What causes a car to ping?

Pre-ignition.


What cancer causes do you have control over vs those you do not?

There are some causes of cancer that you have no control over, such as genetics. There are causes which you can control such as smoking, drinking, and diet.


What causes the ignition where the key goes to lock up snd will not turn at all?

I am not sure what causes this, but I have had times when my ignition key would not turn. The solution to the main problem is to turn the steering wheel slightly. This usually allows the ignition key to turn.


What are causes for 1993 grand am to have no spark?

Defective ignition control module, bad connector or wires to same, broken wire from the crank sensor. The ICM can be checked at a parts store like autozone.


What causes p1361 in 95 parkavenue?

The cause for an error code p1361 on a Buick Park Avenue is ignition control circuit low voltage. The power or wiring leading into the circuit is damaged or incorrect.


What causes ignition control module to go bad?

depends on early or late model. lots of early models will just shut off while driving down the road etc, and never start again. cant rmember right now on late ,mind is on another project, sorry