0
It is usually one or the other. Keys are simple, the key goes in the slot and the pulley is aligned and pushed on. Splines usually have a smooth section on the end of the shaft to rest the pulley on, make slight contact with the end of the splines and slowly turn the pulley until you feel the splines match.
Still curious? Ask our experts.
Chat with our AI personalities
Vivi
Jordan
DevinAdd your answer:
Earn +20 pts
Do axle splines go bad?
If the nut isn't tight on the end of the axle, the splines on the axle, in the hub or both can wear out.
What is an axle spline?
Splines are parallel grooves on the side of a shaft that engage with matching grooves in a socket. They allow power to be transmitted between two rotating elements. Splines are used on axles to allow them to be removed and replaced.
How do you reconnect the wiper arms on a 1973 dodge dart?
Put them in place on the windshield where they should be and then press the arms onto the splines on the posts sticking out of the cowl panel.
What are the techniques on manipulating pencils?
What are the techniques of manipulating pencil
How much does walmart charge for cutting keys?
Walmart does not charge for cutting keys.
