1. Open cup holders and remove (2) Phillips 7mm screws. 2. Unsnap and remove dual power outlet assembly from lower storage. 3. Open lower storage door and remove (2) 7mm screws inside. 4. Models with DVD - Remove DVD player and remove (2) 7 mm screws from behind and (2) 7 mm screws near the floor. 5. Remove lower storage compartment . 6. Remove (2) 7mm screws (facing up) from under cup holder.
Chat with our AI personalities
There is one bolt (10mm) i think, one under the radio and 2 in the deep end of the back of the console.
There is also one in the middle just behind the shifter. The one in the front is hidden by a cover (round). They are all 10mm.
If it is the type with the sliding door on the console, make sure the ignition is on, but engine off, and press the button under the handle at the back of the console (the handle separates the two sections of the console) and this will release an electronic lock and this moves the console back and forth. The diagnostic socket is also under here!
Open the console lid.
Remove the console compartment inserts.
Remove the transmission select switch (if equipped).
Remove the nuts that retain the rear of the console.
Remove the cup holder insert.
Remove the screws that retain the front of the console to the vehicle.
Remove the console from the vehicle
I had this problem too, after a little search i found page with photos. Its shows how to remove car stereo from corolla, but it also answers your question. Hope this help you. http://www.fitaudio.com/?View=entry&EntryID=12
Just remove the console and you can get to it.
Remove the center switch console. remove the 4 spring clips holding the square heater motor housing and remove the housing. Inside the heater motor housing Remove the two spring clips holding the heater motor in Remove wiring connections and then remove the heater motor. Install new heater motor and installation is in the reverse order of above.
When changing the lights on a 1995 Acura Integra remove the dash on the center console and pull it off. Remove all the accessories and reach the old bulbs. Replace the bulbs.
remove the screws which are hard to get to.