0
You turn up the thermostat and the induced draft fan fails to start. This is most likely to be a problem with the?
Wiki User
∙ 7y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Why induced draft fan capacity is more compare to forced draft fan in power plant?
Because it is induced
How induced draft fan works?
flue gas out
What type of air cooler is normally preferred forced draft or induced draftwhy?
the induced draft type is more expensive than the other type, however it is often preferred because it is more efficient.
Forced draft fan vs induced draft fan?
In a balanced draft boiler, you actually have both: forced draft (FD) fans supplying air to the furnace, and induced draft (ID) fans removing flue gas. Typically, the FD fans control airflow, while ID Fans control furnace pressure to slightly below atmospheric pressure. In general though, the choice between forced draft and induced draft is based on how "tight" the system is - if you have leaks, it is better to use ID, as FD will cause product loss.
Were us army doctors in the Korean war drafted or volunteered?
Drafted or draft induced volunteers.
What is an induced-draft air-cooled condenser?
relies on natural convection and doesn't use a fan
What was a major problem for the US in 1970s?
The Vietnam War was a major problem and the continued draft.
Can Forced draft fan can be used as a induced draft fan?
A forced draught is where the air flow comes directly from the fan to the object. Such as an hair dryer.An induced draught is where the air flow is induced {lit lead in} by a separate flow of air. For example, an abrasive jet would quickly wear out if the abrasive passed through the jet nozzle. the flow of abrasive is added (induced) into the air flow by a jet of clean air.If an air flow is corrosive or very dirty then an induced flow system would be appropriate.
A typical induced draft furnace uses a blower off delay in cooling mode why?
increase the efficiency of the system
What is the sequence of operations of gas furnaces?
Thermostat calls for heat. Induced draft fan motor starts. Vent pressure switch verifies pressure. Simultaneously gas valve opens and ignitor lights burner(ignition varies: hot surface ignitor, electronic spark ignitor, or standing pilot). Flame is sensed. High limit temperature switch is made. Blower fan runs. Thermostat calls for no heat. Gas valves close. Burners shut off. Induced draft fan shuts off. Blower fan put into fan delay(fan blower continues to run). Low limit temperature switch made. Fan blower stops.
Is forced draft has negative pressure drop?
No, the forced draft fan has positive pressure as it just forces yhe air into the combustion chamber.only the induced draft fan has negative pressureas it removes the flue gases & exhaust gases is stacked up
What is a balanced draft and how is it controlled?
furnace equipped with FD(force draft) and ID(induced draft) fan /blower are called balanced draft system.Fd used to regulate combustion airflow while ID used to regulate furnace pressures type of furnace operate slightly below ATM pressure .
