0
You hear a clunk in the rear when you hit the gas of your Lexus ls400 92 what could this be?
Wiki User
∙ 16y ago
Broken exhaust hanger? Loose rear shock absorber? Worn shock mount bearing?
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
What is wrong when you hear a clunk upon starting your car?
It could be many things. Go get your car checked.
You hear a sort of clunk when the car is downshifting is this an indication of transmission problems?
most likely the U joint
When turning right you hear a clunk sound?
the stabilizer bars on the rear end usally the bushing s wear out
What would cause 94 explorer front clunk?
It depends on when you hear the noise, but it likely a joint in the front wheel drive unit.
What could be the problem in Honda Civic starting as you only hear hear a single hard clunk?
See if you can turn the crankshaft by hand. If you can turn the crankshaft 360 degrees you probably have a starter motor that's failed. If the engine won't turn completely, it's probably a thrown rod.
How can I tell if my window regulator is broke on 2000 vw beetle?
You can tell if your window regulator is broken on a Volkswagen Beetle when you hear a big clunk as it goes down.
How do you I get my CD changer to work in Lexus ls 400?
i have a 1992 lexus ls 400...the cd won't play..you can hear the cd changer ...but no sound
When I am in a stop and then step on the gas I hear a clunk and the transmission doesn't catch till like 2 seconds later What can the problem be?
I don't know! Ask a mechanic or something.
When you come to a stop something in your front end seems to be loose or pop out of place and then back into place when you resume accelerating what could this be?
Have the drive shaft u-joints checked. When u-joints start to go bad, you will usually hear a clunk when coming to a stop and then again when you accelerte.
Will a vintage Lexus have more value?
you know I hear dinosaurs are coming into fashion. you should check into that
Can you put a 98 suburban transmission into a 97 suburban?
yes , as long as it is same engine block,be sure to use your old torque converter, and put tranny fluid in converter before installing it onto trans , when putting it on trans push it on turn to the right hear a clunk keep turning to right hear another clunk and there ya go it is seated properly. using your old torque converter ensures the fit to the flywheel
When I am in a stop and then step on the gas I hear a clunk and the transmission doesn't catch till like 2 seconds later.What can the proble be?
What's a proble? I think that's the real question here.
