Well, yes, and no. You CAN'T just disconnect the wires from the 60 amp outlet and connect them to three 20 amp outlets. It would be more like tearing out and rebuilding than converting. The 240 volt outlet has a hot wire from each side of the breaker box and each can supply a series of standard outlets if you replace the 60 amp breakers with 20 amps and pull 12 gauge wires.
Actually you CAN just disconnect the wires and connect several 20 amp outlets, IF you change the breaker to a 20 amp one. The breaker/fuse has to be sized for the lowest current link, in this case it is not the wire but the outlets. The wire will be oversized but it does not need to be replaced. Some older dryer circuits also did not include a ground, so you will have to run a grounding wire or install a GFI.
<><><>
As always, if you are in doubt about what to do, the best advice anyone should give you is to call a licensed electrician to advise what work is needed.
Before you do any work yourself,
on electrical circuits, equipment or appliances,
always use a test meter to ensure the circuit is, in fact, de-energized.
IF YOU ARE NOT ALREADY SURE YOU CAN DO THIS JOB
SAFELY AND COMPETENTLY
REFER THIS WORK TO QUALIFIED PROFESSIONALS.
The customary solution is to install a 4 pronged dryer wire. Readily available.
Different plugs are designed so that you can't plug an appliance into the wrong voltage. A dryer is usually 220-240 Volts and your standard outlet is 110-120 Volts. You can't do what you suggest.
50 amp 3 and 4-wire.
Yes is ok as long as you increase the size of the plug .I use dryer plugs( 30 amp )all the time on equipment that came with smaller plugs (20 amp).
You can plug the air conditioner into any outlet in your home, however you should get an outlet strip to protect against power surges. Yes, this HDTV plugs into a normal electrical outlet or power strip.
It is a receptacle outlet wired into a home with the capacity to handle the amperage rating of the range. The cord on the range plugs into this receptacle to receive its power supply so that the range can operate.
The plugs are different. The prongs are straight on one and angled on the other. The wire and breaker are the same. You can either change the outlet or the cord.
Different plugs are designed so that you can't plug an appliance into the wrong voltage. A dryer is usually 220-240 Volts and your standard outlet is 110-120 Volts. You can't do what you suggest.
Its a plug which contains a pronged earth which is the 3rd prong, some other plugs contain only 2 prongs and a 'scratch earth' which is only slight visible, its basically the same concept only one is more visible.
the outlet being used (like plugs for cords)
You can get a tester that plugs into the outlet at any home improvement store.
A charger (like cable - plugs into an outlet) and charges from an outlet on the wall...?
All three prong dryer cords should fit all three prong outlets. Dryer and stove plugs are different but as long as someone didn't use one in place of a dryer cord, there isn't a problem.
A fear of wires, plugs or anything that can be plugged into a wall or outlet.
50 amp 3 and 4-wire.
If the dryer itself already includes a socket outlet that was designed to power a stackable washer then you should have no problem as long as the home's Dryer Circuit, and its breakers, can support the extra Kilowatts of power which the washer will take.To your question "Is there an adapter that would allow for separate use of the washer in its own outlet" the answer is No.Even if the stackable washer is mounted on top of the dryer it may still be possible to plug the washer into the existing, but separate, socket outlet that is intended to power a washer. If you cannot do that then it is best that you call in a licensed electrician to advise you.IF YOU NOT ALREADY SURE YOU CAN DO THIS JOBSAFELY AND COMPETENTLYREFER THIS WORK TO QUALIFIED PROFESSIONALS.If you do this work yourself, always turn off the power at the breaker box/fuse panel BEFORE you attempt to do any work AND always use a meter or voltage indicator to insure the circuit is, in fact, de-energized.
Yes is ok as long as you increase the size of the plug .I use dryer plugs( 30 amp )all the time on equipment that came with smaller plugs (20 amp).
You can plug the air conditioner into any outlet in your home, however you should get an outlet strip to protect against power surges. Yes, this HDTV plugs into a normal electrical outlet or power strip.