0
Mark dist. well before removal & do not roll over motor. If the motor has beed cranked with the dist. out then you will have to get a manual & follow it to a "T". otherwise your cam sensor will be out of phase with you crank sensor. Some allow for small ammounts of adjustment.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Where is the ignition coil on an 1982 gmc 305?
Follow the wire that comes out of the distributor (obviously not the wires that go to the plugs)
Where is the cam shaft sensor located on a 96 gmc serria 1500 pickup with 305 vortec motor?
Inside the distributor.
Oil sending switch 1991 GMC pickup 4x4 305 engine?
It is on the back of the engine, just behind the distributor.
Why doesn't Distributor on a 305 GMC turn?
remove distributor and check the gear on it.if gear is ok then remove front cover and check timing chain or broke camshaft.
How do you install a distributor in a 1996 Yukon?
I removed the distributor in my 96 gmc yukon but I forgot to mark it before removing it.What do I need to do to get it back in.
What is the correct ignition timing on a 1997 gmc sierra with a 305?
The timing for this engine is electronically controlled and not adjustable
Where is the camshaft position sensor located on a 1997 GMC Sierra?
its located in the distributor at the back of the motor.
Where is the oil pressure sensor for a 1997 GMC Suburban?
On the driver's side next to the distributor; hard to get to.
How do you time a 1997 GMC Jimmy?
by a mechanic you have to use a hand held computer you can not do it by the distributor as older cars could do.
What is the difference between a Chevrolet 305' and a gmc 305?
Nothing.
How to install a power steering pump on a 1997 GMC sierra 1500?
How to replace a power steering pump on a 97' GMC sierra 1500
How do you remove the rotor from the distributor shaft on a 1994 GMC 1500 pickup truck?
Not sure what engine you have, but my1992 305 has a roll pin on the end of shaft that is knocked out to remove gear
