0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Why is vacuum advance on distributor hitting the intake manafold on small block Chevy?
The distributor is off a tooth or two. You can pull the distributor out and turn the rotor a little and put it back in. Then re-time the engine.
Can you put a tach on a stock 87 Chevy 305 distributor?
Yes you can no problem.
Can you take a 1994 Chevy caprice 350 LT1 and put it into your 1993 Chevy Suburban 350 TBI after you switch intakes and put in the distributor?
Yes you sure can
How do you remove the distributor on a 4 cylinder Chevrolet Celebrity?
To remove the distributor on your Chevy Celebrity 2.5L 4 cylinder engine: 1, Set the timing to the number one cylinder in the firing position. 2. Remove the distributor cap and put out of the way. If you take out any of the spark plug wires make note of where to put them back. 3. Loosen and remove the retainer clamp and its bolt. 4. Pull the distributor out of the block. To reinstall the distributor reverse the instructions. You will need to re-time the engine when you put the distributor back in.
What cOIL should you put for a 350 chevy engine with a HEI mallory distributor?
Stick with the coil recommended by Mallory.
How do you install a rotor cap in a Chevy Silverado?
all you should have to do is take the distributor cap off, and there it is. answer take the distributor cap off, pull the old rotor off, put the new one on, put the cap back on.
How do wire up a Chevy 305 distriputer and starter on a 1986 Chevy Monte Carlo SS?
startet has nothing to do with it, but just put the crank on TDC and line up the distributor to #1
Why i have no spark from distributor Chevy 350 crate motor in my 84 Toyota fj60?
Did you put power to the right terminals on the distributor? (one from battery,one from ignition) Did you run a ground strap to the engine? Good luck.
What is a camshaft to crankshaft position on an 1996 Chevy Tahoe?
You must have been fooling with the distributor. You MUST have an engine scanner to set the timing on that engine. That will then put the cam and crank sensors back in correlation / Time with each other.
Can you use a 283 intake manifold fit on a 350 Chevy engine?
Yes, as long as it is a pre 87 350. In 87 Chevy changed the cylinder head configuration, and thus takes a different intake. The only isue here is the place you put the oil in. On early 283's, there was a hole in the front of the intake, to put a tube, to put opil in. There were no holes in the valve covers. Newer stuff, they eliminated that hole, and you put oil into the valve covers. Just make sure you have the proper set up. It does not matter where you put the oil, either spot, but, just so you can.
How do you put distributor in 2002 blazer 4.3?
how to install a distributor
You have 1986 Chevy astro van 4.3 v6 you need to know what do you need do to put the distributor rotatel back in time?
Purchase a repair manual at most parts stores, ( around $12 ) for detailed instructions on this and many other repairs.
