0
Remove the kick panel covers, the lower portion of the dash, remove the lower half of the covers on the steering column. You will have to cut about 3 or 4 wire ties. you will need a special tool to remove the bolts from the existing ignition switch, (it looks like a reverse torx screw). To remove the other end of the existing Ignition switch cable you will need a nut driver to remove the connector. Remove the two additional connectors on the outside of the connection. Re-install the additional connectors onto the new switch harness. Connect the adaptor and tighten the bolt. install the switch and tie the harness back into place. replace the cover and Dash panels.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How do you change the ignition switch on a 2004 gmc 1500 sierra truck?
how to remove cover to replace ignition lock cylinder and what type of tools do i need
How doi remove ignition without key from 1986 Toyota pickup truck?
Begin by removing the retaining ring at the top of your 1986 Toyota pickup truck ignition switch. The ignition switch will slide out. Remove the wiring harness from the back of the ignition switch.
How do you replace an ignition switch for a 1977 Chevrolet truck?
n ignition switch on a 1991 Chevrolet astro vanAnswern ignition switch on a 1991 Chevrolet astro van
Wiring diagram for ignition switch for 1974 Chevy truck?
Ignition wiring diagram
When I start my 1997 V6 Sonoma it starts then stops Does that a few times then goes all right Sometimes while driving it will die then go again?
My 97 Sonoma was doing the same thing and a good tech found it was a bad ignition switch. The truck runs great again.
Key turn truck on but will not turn truck off?
Probably a bad ignition switch.
How do you change the ignition switch on a 1989 Ford truck?
I just purchase a f150 that needs a new ignition switch and the man at auto zone gave me directions with pictures and diagrams, I hope this is of some use. Good Luck!
Where is the relay switch on 1993 Sonoma truck?
It is under the dash with some wires plugged into it. At least that where it is on mine.
How do you remove the ignition switch cylinder to replace it on a 1971 Chevy truck with no key?
With no key you will have to drill out the existing tumbler assembly from the switch in order to unscrew the ignition switch bezel.
Why would my truck not start with aNew starter battery alternator?
check the wiring change the starter relay and clean ignition switch with electicial cleaner.
How do you remove an ignition switch from a 1979 Chevrolet C10 pickup?
Remove the retaining ring from the top of your 1979 Chevrolet C 10 pickup truck ignition switch. Slide the ignition switch out and remove the wiring harness.
How do remove the ignition switch on 1978 Chevy truck?
High-powered explosives.
