cycle the key three times and count the blinks of the check engine light
The codes on a 1994 Sundance are 2 digit codes. Code 3 is not correct.
Go to www.installdr.com its where i got the diagram for my 92 sundance
Code 43 refers to the coil. Code 55 is end of message.
Most Auria televisions use the same codes as NEC models. Check the manual on your universal remote for the code for NEC televisions.
Television X do not publish legitimate free access codes.
The codes on a 1994 Sundance are 2 digit codes. Code 3 is not correct.
Go to www.installdr.com its where i got the diagram for my 92 sundance
if you disconnect the battery for at least 5 minutes then reconnect it ,it will reset the check engine light
Code 43 refers to the coil. Code 55 is end of message.
After reading the code, and repairing the codes, you reset code with a scan tool.
turn the key on and off 3 times and count the check engine flashes
Turn the ignition key off and on three times. You will see the check engine light go off and on. Count the times the light goes off and on. Those are the codes.
Either with a scanner, or cycle key on, off,on,off,on. and count the flashes of the check engine light. three pause three would be 33
The code numbers are two didgit codes. That was probably a 12 and a 55. 12 is start of message, 55 is end of message. Basically that means there are no trouble codes.
The first step is to have the codes checked with a scan tool. That will give you a starting point as to what the failing part could be.
Count again. Without starting the car, turn the ignition ON-OFF-ON-OFF-ON. After a few seconds, the check engine light will flash out the trouble code. It will consist of two digits with a very short pause between. Then there will be a longer pause after which the the next trouble code (if any) will flash out. After all the codes have flashed out, the computer will flash 5-5. Fifty five is the indication that all the trouble codes have been revealed. The computer will repeat all the codes a second time. By the way, if the code flashed out is 13 (as opposed to 13 flashes, it indicates a problem with the car's MAP sensor.
Yes, P0700 is a code in the engine computer that tells you to check the trans computer for codes. You check those codes and repair them and P0700 will go away.Yes, P0700 is a code in the engine computer that tells you to check the trans computer for codes. You check those codes and repair them and P0700 will go away.