0
Add your answer:
Earn +20 pts
Which of these is a typical design for IED detonation?
time delay
How many pounds of rebar are in a typical concrete slab on grade?
There is no way to answer without a design and the square footage.
What are the 6 typical c plus plus Development environment and phases?
Design, flowchart, encode, compile, test and debug.
Which is the correct order of different process steps for a typical FPGA design?
synthesis, simulation, timing verification, place and route
Why is IED called Roadside bomb?
Because Improvised Explosive Devices are often used to disrupt transports and traffic (which occur on roads).
What is the typical design for an IED detonation?
time delay
Which of these is a typical design for IED detonation?
time delay
Which of these is a tyical design for IED detonation?
timed delay
What is a typical design for an IED?
what are the types of ied switch
What is a typical design for IED detonator?
victim operated
What is EFP IED?
what component of an IED is used to start detonation
What component of an IED us used to start a detonation?
what is the primary component of an ied
What component of an IED used to start a detonation?
what is the primary component of an ied
What is EFPS?
what component of an IED is used to start detonation
What component of IED is used to start a detonation?
initiator
Which component of an IED creates an electrical charge?
The component of an IED that creates an electrical charge is typically a battery or power source. This electrical charge is used to initiate the explosive material or trigger the detonation mechanism of the IED.
What component of an IED starts the detonation?
The detonator is the component of an IED that initiates the explosion by igniting the main charge. It is typically a small device that is triggered by a timing mechanism, remote control, or pressure sensor.
