Hydraulic motors are commonly used in military vehicle wheel motors, crane drives, high powered lawn trimmers, and winches. William Armstrong was one of the first to construct a hydraulic motor.
Electric wheelchairs are demanded heavily for these exact reasons. Your best bet would probably be at: http://www.spinlife.com/category.cfm?categoryID=3
Electric High was created on 2009-10-05.
You can think of it as a motor that is very strong. If you were to try and hold the wheel of a 1000cc motorbike you would not be able to stop it from moving because it has tremendous torque in lower gears. High torque means greater acceleration, which means you will need better tires to prevent wheel spins.
in an antique high wheel cultivator handle shop.
High Light Electric Inc. was created in 1996.
2 wheel low 4 wheel low Neutral 4 wheel high 2 wheel high
If it has 4-wheel drive you would see controls on the dash to engage 2-wheel high, 4-wheel high or 4-wheel low.
Yes you can, but don't drive over 50 to 55 MPH
This depends entirely on the vehicle. My Land Cruiser specifically recommends not doing this My Dodge pick up does not mind.
the front wheel was bigger than the back wheelThe most unusual thing about the Penny-farthing bicycle is that it was a high wheeler. The front wheel of the bike was very high while the back wheel was very small.The penny farthing ( also known as the high wheel, high wheeler and ordinary) has a large front wheel and a small rear wheel. The front wheel is directly driven by the pedals. It took a lot of skill to ride the ordinary without coming to grief.There was a very large front wheel and a very small rear wheel. There was a direct drive from the pedals to the front wheel. The rider was seated high and had to learn the technique of starting and stopping the penny farthing - which was also known as the high wheel, high wheeler or ordinary.It was called the Penny-Farthing. Those were two different sized coins. The front wheel was large, the rear wheel very small.
the front wheel was bigger than the back wheelThe most unusual thing about the Penny-farthing bicycle is that it was a high wheeler. The front wheel of the bike was very high while the back wheel was very small.The penny farthing ( also known as the high wheel, high wheeler and ordinary) has a large front wheel and a small rear wheel. The front wheel is directly driven by the pedals. It took a lot of skill to ride the ordinary without coming to grief.There was a very large front wheel and a very small rear wheel. There was a direct drive from the pedals to the front wheel. The rider was seated high and had to learn the technique of starting and stopping the penny farthing - which was also known as the high wheel, high wheeler or ordinary.It was called the Penny-Farthing. Those were two different sized coins. The front wheel was large, the rear wheel very small.