Basically a vasectomy is the cutting of the two vas deferens cords which carry spermatozoa from the testes to the ejaculate. Once ligated exorcised and ligated the tubes cannot carry the sperm and therefore is a most effective form of Birth Control with a chance of less than 1% pregnancy rate. Note this will make the man sterile and is very difficult to repair surgically. You should be sure that you do not want any further children before undertaking this procedure.
Clamped
If the cutting tool is not tightly clamped in the tool post it could move when a cut is taken. This can result in the tool penetrating the workpiece as the cut progresses causing an undersized workpiece. It can also eventually bite into the workpiece and possibly cause damage to the workpiece, the lathe, the cutting tool and even injury to the machinist and others in close proximity.
The main difference is the following: On a CNC Lathe the material to be worked is held in a chuck and rotated around and the tools are clamped. These tools are then moved against the rotating material to cut into it. On a CNC Mill the tools are held in a chuck and rotated around and the material to be worked is clamped. These tools are then moved against the stationary material to cut into it.
The swing of a lathe can be increased if the gap-bed section is removed, providing the lathe has this option and the workpiece is not longer than the gap when clamped in the chuck.
When measuring a load current, an ammeter is connected in series with the load. The exception is for a clamp on style AC ammeter, which is clamped around one of the conductors, making its measurements as a transformer.
Here are some sentences.She clamped the pipe in the vice to work on it.The lid was clamped shut on the box.
He clamped his hand tightly around the paper.
A frenectomy is a simple procedure that is done in the dental office using local anaesthesia. A hemostat is clamped to the frenum and using a scalpel, the tissue is cut away from the top and bottom of the hemostat. After removal of the tissue, the remaining tissue are sutured to avoid reforming a new frenum.
the two boards were glued, then clamped together following the instruction diagram.
Yes it is possible. Having clamps and then having the procedure reversed leads to excellent healthy fallopian tube lengths. This is one of the best tubal ligation methods to reverse.
Stamped
Yes, You can go through Menopause with or without your tubes clamped. It's normal.
Mulugeta K. Berhe has written: 'Damping in a clamped-clamped vibrating tube with intermediate supports'
Clamped
i just want to know how much in Halifax ns it is to reverse a tubal ligation (i just had my tubes clamped) it was donr aug of last yr.
It is clamped or tied, then cut.
The transom on a boat is the stern on which an outboard motor can be clamped.