0
Add your answer:
Earn +20 pts
What size is the oil drain plug on a 1995 Toyota Avalon?
the plug head is 14mm, the threads on the bolt should be about the same size in order to fit the welded nut in the bottom of the oil pan
What is Oil drain plug size on 2005 Chevy Malibu 2.2l?
The 2005 Chevy Malibu 2.2 liter engine oil drain plug size is 9/16. The oil drain plug has very fine threads.
How do I fix the threads or install a helicoil that hold the spark plug in a lawn mower?
find the right size helicoil and drill out the hole to the proper size and install
What is the size of the oil drain plug on a 1993 Lincoln town car?
The drain plug, on a 1993 Lincoln town car, is 5/8. The drain plug has special threads and cannot be replaced with a regular bolt.
What is the size of the oil drain plug on a 2000 Chevy Tahoe 5.7l?
The 2000 Chevrolet Tahoe 5.7 liter engine oil drain plug is a 9/16 drain plug. The oil drain plug has very fine threads.
How do you put dielectric grease on spark plug wires?
Just apply a small dab the size of a tic tac on both ends of the spark plug wire. Also a small dab of anti seize on the spark plug threads will help as well.
What is the standard size and pitch of bicycle pedal threads?
The standard size and pitch of bicycle pedal threads are 9/16 inch and 20 threads per inch.
What is the standard size and pitch of bike pedal threads?
The standard size and pitch of bike pedal threads are 9/16 inch and 20 threads per inch.
What is the thread size for a 2008 Honda Accord 2.4 oil pan?
The honda oil pan drain plug is a 14mm bolt. It's threads are a 1.50 pitch.
What is the size of 351 windsor block freeze plug above starter. I know that is a its a npt pipethread?
If it is a freeze plug it would not have threads. Freeze Plugs are designed to pop out of the block should the water in the block freeze. This could not happen if the plug was threaded. Hope This Helped.
What tool is used to get a stripped spark plug out?
Did you strip the actual plug is rounded off or did you strip the plug threads? If you stripped the plug itself and can get to it use vise grips. If you cannot get to the plug then go to your local parts store and tell then what happened. I know Snap On makes a special socket to remove rounded off bolts and spark plugs. Now if you actually stripped the spark plug threads then you may be able to just chase the old threads with a tap and clean them up enough that you can insert a new plug. Use anti-sieze compound and do not over tighten. 13 ft/lbs and no more. If that is not possible you will have to purchase a Helicoil. You local parts store can sell you the correct size and tell you how to use it.
What is the recommended drill size for tapping threads with an M3 tap drill?
The recommended drill size for tapping threads with an M3 tap is 2.5mm.
