nominal cooling capacity is the derated cooling capacity at a certain design condition. Rated cooling capacity is the cooling capacity at sea level
Nominal cooling capacity is the suppliers or manufactures equipment rated capacity based on the test conditions. Test conditions always varies to design conditions, therefor in most cases the Nominal cooling capacity is more than the design or actual cooling capacity.
There are two measures used to describe the cooling capacity of an air conditioner. One is BTU or 'British Thermal Unit' but that is the old way of doing it. The modern way is the Kw or Kilowatt of cooling. to get BTU you have to multiply Kw by 3412. A small air conditioner for maybe one person in a little office might be 9000 BTU or 2.6 kW, a large industrial air conditioner for a bigger area might be 35,000 BTU or 10.26 kW.
the spesific heat capacity of a liquid by the mithod of cooling
If the air conditioner is on but not cooling the house properly, you may have a leak in your duct work. A leak would allow all of the cold air to escape, blowing into the outdoors instead of cooling your house.
Why is there humidity in the room when air conditioner is cooling? Room feels damp.
What is the difference between rated capacity and the nominal capacity
In general actual capacity is bit less than the nominal capacity of any form
Precision A/C systems are primarily designed for cooling electronic equipment, rather than people. These pre-packaged systems offer excellent reliability and typically have a high ratio of sensible-to-total cooling capacity and a high CFM/ton ratio.
The answer to this question would depend on the tonnage (cooling capacity) of the unit.
One kicks on for normal cooling, they both kick on when the air conditioner is turned on.
Heatsink uses what they call passive cooling where as liquid cooling systems use active cooling.
calculation for cooling tower evaporation capacity.
heating curve is hotter than the cooling curve
There is no such thing as and air-conditioner accumulator in an automobile. A nonworking air-conditioner compressor can cause a cooling malfunction.
Nominal cooling capacity is the suppliers or manufactures equipment rated capacity based on the test conditions. Test conditions always varies to design conditions, therefor in most cases the Nominal cooling capacity is more than the design or actual cooling capacity.
usually both the same thing just different names. Most hydronic (water) systems are referred to as cooling coil and heating coil. Direct refrigerant system is an evaporator coil. Also depends on who your talking to.
There are two measures used to describe the cooling capacity of an air conditioner. One is BTU or 'British Thermal Unit' but that is the old way of doing it. The modern way is the Kw or Kilowatt of cooling. to get BTU you have to multiply Kw by 3412. A small air conditioner for maybe one person in a little office might be 9000 BTU or 2.6 kW, a large industrial air conditioner for a bigger area might be 35,000 BTU or 10.26 kW.