Cutting Speed :- Rate at which point on work circumference travels past cutting tool.It always express in feet/min.and if it is too high cutting tool breaks down rapidly and if too slow low production rate occurs.
Feed :- The distance that cutting tool advances along the length of work piece for every revolution of the spindle.
Feed of a cutting tool in the lathe is the distance of the tool advances for each revolution of the work.The depth of cut is the perpendicular distance measured from the machined surface to the uncut surface of the work piece.
cutting speed is a combination of depth of cut and feed.
feed mm/sec speed Rev/min RPM for cutting tool
How fast lathes, cutting speed can be fast, it has a relationship with the feed amount and diameter.
orthogonal cutting is a 2D cutting having 2 forces i.e cutting force and feed force where as oblique cutting is a 3D cutting having additional force i.e radial or passive force.
The feed rate is the distance the cutting tool moves during one revolution of the machine's spindle. RPM (Revolutions Per Minute) is the speed at which the spindle rotates. Together, the feed rate and RPM determine the cutting speed, which affects the material removal rate, surface finish, and tool life during machining operations.
In generating, the geometry of the workpart is determined by the feed trajectory of the cutting tool. On the other hand in forming, the shape of the part is created by the geometry of the cutting tool.
Obviously it would depend on the stainless grade because stainless is an alloy, so the speed rate would differ slightly depending on your grade. The most important factor would be the type of cutter you use, if you are using Carbide cutting tools, with sufficient coolant you can run it at about 90-110 m/p/m (90 to 100 meters per minute) If you using high speed steel cutters run it no more than about 30m/p/m. My best advice to you is to ask for the manufactures recommendations they will give you a limit to work in, always start between lowest and middle of manufactures speed recomendations and then work your way up in speed if necessary. If your speed is correct you get a better finish and longer toolife. Remember that if you run tools at higher speeds you decrease their life, the time taken to cut the material is determined by the feed-rate and not the speed, even on a lathe which has feed set to federate per revolution will only differ slightly. Hope this helps…
the difference is that animals feed on other plants and sometimes animals and flowers feed off the sun and water.
The difference between 150 and 350 digital channel feed in the cable TV lies with the quality of the video.
Food: Something you eat. (Noun) Feed: To eat something. (Verb)
They are the percentage of protein in the horse feed.