The Urei 6250 power amplifier has a power output of 250 watts per channel into 8 ohms.
You can determine the impedance (ohms) of a car amplifier by checking the specifications provided by the manufacturer. Look for information on the minimum stable impedance the amplifier can handle per channel. If it can handle 2 ohms per channel, then it is a 2-ohm amplifier. If it can handle 4 ohms per channel, then it is a 4-ohm amplifier. Typically, this information is found in the technical specifications or manual of the amplifier.
rated at 22.5 watts per channel in stereo and under a 4 ohm load per channel.... although the birth sheets they were shipped with normally stated the wattage as tested to be around 75 to 86 watts per channel in stereo running on a 14.4 volt system... bridged possiby as much as 150 to 200 on 14.4 volts !! very stout little amps and ive seen two run 8 rockford 15's back in the day !! WOW !!
Typical car stereos run speakers at 4 to 8 ohms, so I would wire the two 16 ohm speakers in parallel to get a net 8 ohms. Anything over that would be a little much for a car stereo. You don't need to drive it that hard.
wire two 8 ohm speakers in a parallel circuit!
It depends on the application. If you have an amp that is stable in 8 ohms per channel, then 8 ohm speakers will work best. However, if you wanted multiple speakers on that channel you could use two 16 ohm speakers.
They're both the same. A "channel" stereo receiver merely accepts a given number of channels (2,4,5, &tc.). A stereo receiver has 2 channels of audio output, left and right. A receiver marked as ___ channel receiver has the corresponding number of channels. For instance a 5 channel stereo receiver can play 5 different channels of audio through 5 speakers. If the receiver has a decimal, such as 5.1 or 7.1, that indicates that it has 5 or 7 channels of regular audio, plus 1 channel for subwoofer, making them 6 and 8 channels, respectively.
yes, because Pyle Pro 8 Channel Stereo Pa Mixer Sound Board has all Input Channels Features LED Peak Indicators For Visual Signal Monitoring and has 3 – Band EQ(High – Mid – Low) On Each Input Channel .
16 Ohms. Yes 16 ohms in series. 4 ohms in parallel
The nominal 8 inch speaker impedance can be 4 ohms, 8 ohms or 16 ohms. It depends on the make of the loudspeaker not on the 8 inches.
3 passive sub at 8 ohm imp in parralel will be 2.6+ impedence.Most of the professional sum amp can take up to 2 ohms load per channel(check the spec of the Amp)eg: you should be able to connect max 4 subs in each channel(match the watts pwr to amp)
According to the Wire resistance tables, 8 AWG has a resistance of 0.6282 ohms per thousand feet.